Predator is always inventing and it’s a good thing too because that relentless pace is responsible for great products like their QR Mini Extension. Better than a bridge, the QR Mini Extension seamlessly adds 3″ to the butt of your cue!
Predator’s quality is second to none. The excellent QR Mini Extension has been created using the same attention to detail for which Predator is renown. As with all things made by Predator, this device will last a long time.
If you’ve never had the chance to try a Predator QR Mini Extension on your cue, we’ve got you covered with our Hands-On Video and exclusive photos of the Predator QR Mini Extension from every angle. It’s like trying it for yourself!
As you would expect from a company like Predator, the QR Mini Extension is very well made. The construction is a high-gloss plastic with removable cap covering the threaded pin.
This device fits snuggly on any of the Predator cues listed below:
BK III Series
IKON 2 & 3 Series
Sport II Series
Limited & Special Edition (2012 & newer)
Molinari by Predator Carom Cues
How It Actually Plays:
The QR Mini Extension fits onto the butt of your compatible Predator cue. It fits snuggly and literally becomes an extension of your cue’s butt. The addition of an extra 3” to the back of your cue suddenly allows you the freedom to make those hard-to-reach shots without resorting to using a bridge. Does it actually work? You bet it does!
This is a great product and it is a big help for situations where you want to shots that would otherwise require a bridge. If you have a Predator cue, getting one of their QR Extenders is a no-brainer. Buy it and keep it in your cue case so you’ll be ready for that next just-out-of-reach shot.
The new QR Mini Extension2 from Predator pairs with any Predator Cue equipped with the Uni-Loc® Weight Cartridge System.
Once installed the quick releasing extension adds an additional 3 inches of butt length with a single turn of the extension handle. Simply remove your existing rubber bumper, install the Uni-Loc® QR Mini Extension2 bumper using a standard 6mm allen wrench, twist on the QR Extension2 handle and you’re ready to go.